Avanti WCR520AS, Инструкция по эксплуатации

Страница: 10 / 24

10
INSTALLATION INSTRUCTIONS

BEFORE USING YOUR WINE CHILLER

Remove the exterior and interior packing.

Check to be sure you have all of the following parts:
1 Instruction Manual
5 Large Shelves
1 Small Shelf
2 Keys

Before connecting this appliance to the power source, let it stand upright for approximately 2
hours. This will reduce the possibility of a malfunction in the cooling system from handling
during transportation.

Clean the interior surface with lukewarm water using a soft cloth.

INSTALLATION OF YOUR WINE CHILLER

This appliance is designed to be for free standing installation, recessed or built-in (fully
recessed).

Place your Wine Chiller on a floor that is strong enough to support it when it is fully loaded. To
level your Wine Chiller, adjust the front leveling legs at the bottom of the Wine Chiller.

Locate the Wine Chiller away from direct sunlight and sources of heat (stove, heater, radiator,
etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Extreme cold ambient temperatures may also cause the unit not to perform
properly.

Avoid locating the unit in moist areas.

Plug the Wine Chiller into an exclusive, properly installed-grounded wall outlet. Do not under
any circumstances cut or remove the third (ground) prong from the power cord. Any questions
concerning power and/or grounding should be directed toward a certified electrician or an
authorized Avanti Products service center.

BUILT – IN CABINET INSTRUCTIONS
This unit is designed for both built-in or free standing installation. If you plan to use this unit in a built-
in application please follow the requirements shown to the right.
←
Figure shown
Cabinet Opening Dimensions
IN (min) MM (min)
Width 24” 610 mm
Depth 26” 661 mm
Height 35” 889 mm
Figure shown
→
Unit Dimensions
IN (min) MM (min)
Width 23
1
/
2
” 597 mm
Depth
(with handle)
24 ½” 623 mm
Depth
(without Handle)
22 ¾” 578 mm
Height 34” 889 mm