11
The cord should be secured behind the unit and not left exposed or dangling to prevent accidental
injury.
The unit should always be plugged into its own individual electrical outlet which has a voltage rating
that matches the rating label on the appliance. This provides the best performance and also prevent
overloading house wiring circuits that could cause a fire hazar d from overheated. Never unplug the
unit by pulling the power cord. Always grip the plug firmly and pull straight out from the receptacle.
Repair or replace immediately all power cords that have become frayed or otherwise damaged. Do
not use a cord that shows cracks or abrasion damage along its length or at either end. When moving
the unit, be careful not to damage the power cord.
Extension Cord
Because of potential safety hazards under certain conditions, it is strongly recommended that you do
not use an extension cord with this unit. However, if you must use an extension cord it is absolutely
necessary that it be a UL/CUL-Listed, 3-wire grounding type appliance extension cord having a
grounding type plug and outlet and that the electrical rating of the cord be 115 volts and at least 10
amperes.
Reversing the Door Swing of Your Appliance
This appliance has the capability of the door opening from either the left or right side. The unit is
delivered to you with the door opening from the left side. Should you desire to reverse the opening
direction, please call customer service for reversal instructions.
OPERATING YOUR UNIT
Setting the Temperature Control
?
Your unit has only one control for regulating the temperature. The temperature control is located
on the lower unit.
?
The first time you turn the unit on, set the temperature control to “6.”
?
The range of the temperature control is from position "1” to “6”. After 24 to 48 hours, adjust the
temperature control to the setting that best suites your needs. The setting of “4” should be
appropriate for use.
?
To turn the appliance off, turn the temperature control to ”OFF”.
NOTE:
?
Turning the temperature control to “OFF” position stops the cooling cycle but does not shut off the
power to the unit.
?
If the uni t is unplugged, has lost power, or is turned off; you must wait 3 to 5 minutes before
restarting the unit. If you attempt to restart before this time delay, the unit will not start.
CARE AND MAINTENANCE
Cleaning Your Unit
?
Turn the temperature control to "OFF", unplug the unit, and remove the food, shelves, and trays.
?
Wash the inside surfaces with a warm water and baking soda solution. The solution should be
about 2 tablespoons of baking soda to a quart of water.
?
Wash the shelves and trays with a mild detergent solution.
?
The outside of the unit should be cleaned with mild detergent and warm water.
?
Wring excess water out of the sponge or cloth before cleaning the area of the controls, or any
electrical parts.
?
Wash the outside cabinet with warm water and mild liquid detergent. Rinse well and wipe dry with
a clean soft cloth.
CAUTION:
Failure to unplug the unit could result in electrical shock or personal injury.
Содержание OR2700SS
Страница 5: ...5...
Страница 15: ...15 Wiring Diagram...
