16 Reinstall the freezer shelf below the ice maker assembly.
Set the ice container below the ice maker assembly.
17 Locate the factory punched holes at the lower right panel
on the rear of the refrigerator.
Align the water valve with the holes and secure the water
valve in place with the four (4) Phillips Head Self-Tapping
screws and a power drive with the Phillips Head bit.
18 Connect the wiring harness to the water valve as shown.
Ensure the connection is secure.
19 Push the plastic water supply tube into the bottom of the
water valve as far as it will go.
Tighten the Nylon compression nut by hand to the water
valve.
Then tighten the nut until it is secure but DO NOT
overtighten using a wrench.
20 Secure the plastic water tubing to the rear of the
refrigerator cabinet with the two (2) plastic clamps
provided.
** NOTE **
Clean the area of the back of the unit where you will be
placing the plastic clamp with household cleaner, ammonia
or alcohol to provide a clean surface for the adhesive to
adhere to.
15 Adjust the leveling bracket to ensure the ice maker
assembly is totally level.
The ice maker will be level when the gap between the
freezer wall and the ice maker assembly is the same at the
top and bottom.
Once completely level, tighten the leveling bracket screw.
