Avanti 1062PSS, Инструкция по эксплуатации

Страница: 11 / 22

11
OPERATING YOUR APPLIANCE
Temperature Control Panels
Setting the Temperature Control
?
To control the internal temperature, adjust the control dial according to the ambient temperature or
purpose of use.
?
The first time you turn the unit on, set the temperature control to “7 ” in refrigerator section and
“MAX” in freezer section .
?
The range of the temperature control is from position “1” the warmest to “7” the coldest in
refrigerator section and from position “1” th e warmest to “6” the coldest in the freezer section . After
24 to 48 hours, adjust the temperature control to the setting that best suits your needs. The setting
of “4” in refrigerator section and middle of “ 1” and “6” in freezer section should be correct for home
or office refrigerator use.
NOTE:
IF THE UNIT IS UNPLUGGED, HAS LOST POWER , OR IS TURNED OFF, YOU MUST WAIT 3
TO 5 MINUTES BEFORE RESTARTING THE UNIT. IF YOU ATTEMPT TO RESTART BEFORE
THIS TIME DELAY, THE REFRIGERATOR -FREEZER WILL NOT START.
TUR NING THE REFRIGERATOR TEMPERATURE CONTROL TO “OFF” POSITION ST OPS THE
COOLING CYCLE BUT DOES NOT SHUT OFF THE POWER TO THE UNIT.
Using Your Ice Cube Tray
?
Recommended thermostat setting for ice making is position “6 ”.
?
Fill the ice cube tray (two thirds of it) with cold water or with any liquid suitable for
freezing and place the tray on the bottom of the freezer to freeze properly.
?
Dry the tray, otherwise it may stick to the bottom of the freezer.
?
The best method to get ice cubes out of the tray is to hold the tray under cold tap
water for a second.
?
To eject the ice cubes from the tray, place over the ice bucket and twist slightly