Avantgarde TBWC-46S, Инструкция по эксплуатации, Страница: 18 / 28

12/21/2010
3-PREPARATION & INSTALLATION INSTRUCTIONS
Before Using Your Wine Cellar
•
Remove the exterior and interior packaging.
•
Before connecting the Wine Cellar to the power source, let it stand upright for approximately 2 hours. This
will reduce the possibility of a malfunction in the cooling system from handling during transportation.
•
Clean the interior surface with lukewarm water using a soft cloth.
•
Install the handle on the door.
INSTALLATION DIAGRAM FOR THE BUILT-IN MODELS
●
Level the unit inside the cabinet.
●
Open the door of the unit at a 90°angle.
•
The cut out dimensions are illustrated on this figure
Installation of Your Wine Cellar
•
This appliance is designed for free standing installation or built-in (fully recessed).
•
Place your Wine Cellar on a floor that is strong enough to support it when it is fully loaded. To level
your Wine Cellar, adjust the front leveling leg at the bottom of the Wine Cellar.
•
Locate the Wine Cellar away from direct sunlight and sources of heat (stove, heater, radiator, etc.).
Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Extreme cold ambient temperatures may also cause the unit not to perform
properly.
•
Avoid locating the unit in moist areas.
•
Plug the Wine Cellar into an exclusive, properly installed-grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions
concerning about power and/or grounding should be directed toward a certified electrician or an
authorized product service center.
Reversing the Door Swing of Your Appliance
The door of this appliance has the capability of opening from either left or right side. The unit is
delivered to you with the door opening from the left side. If you desire to reverse the opening direction,
please refer to the instructions on the following pages or to our website at
www.distributionsavantgarde.ca
19