Avantgarde LBWC-168BSS3, Инструкция по эксплуатации

Страница: 16 / 23

11/11/2010
3-PREPARATION & INSTALLATION INSTRUCTIONS
Before Using Your Wine Cooler
•
Remove the exterior and interior packaging.
•
Before connecting the Wine Cooler to the
power source, let it stand upright for
approximately 2 hours. This will reduce the
possibility of a malfunction in the cooling system
from handling during transportation.
•
Clean the interior surface with lukewarm water
using a soft cloth.
•
Install the handle on the left side of the door.
INSTALLATION DIAGRAM FOR THE BUILT-IN MODELS
•
Level the unit inside the cabinet.
•
Open the door of the unit at a 90°angle.
The cutout dimensions illustrated in the figure.
Installation of your Wine Cooler
•
This appliance is designed for free standing installation or built-in (fully recessed).
•
Place your Wine Cooler on a floor that is strong enough to support it when it is fully loaded. To level your
Wine Cooler, adjust the front leveling leg at the bottom of the Wine Cooler.
•
Locate the Wine Cooler away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct
sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Extreme
cold ambient temperatures may also cause the unit not to perform properly.
•
Avoid locating the unit in moist areas.
•
Plug the Wine Cooler into an exclusive, properly installed-grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning
about power and/or grounding should be directed to a certified electrician or an authorized products
service center.
Reversing the Door Swing of Your Appliance
The door of this appliance has the ability of opening from either left or right side. The unit is delivered to you
with the door opening from the left side. If you desire to reverse the opening direction, please call the Service
Center. (Fees will apply)
15
24”
27”
72”