AVANT A410224, Руководство оператора для насадки, Страница: 15 / 20

15 (20)
.
6.1 Checks before use

Make sure to use correct type of fork.

Ensure that bystanders are at a safe distance when operating the equipment. Do not let anyone to
enter danger area of the boom or to stay directly in front of the loader. Also make sure that it is safe to
reverse with the loader. Never assume that bystanders will remain where you last saw them;
especially children are often attracted to the moving equipment.

Check the general condition of the attachment and the loader, and check for possible hydraulic oil
leaks. The attachment must not be used, if there is a fault in the hydraulic system of the loader or the
attachment. Refer to Chapter 7 for maintenance instructions.

Operate the attachment and the controls of the loader only when seated on the driver’s seat. Ensure
that the loader and the attachment are used in a safe manner and as intended. Do not allow children
to operate the equipment.

Never operate the loader or attachments while under the influence of alcohol, drugs, medication that
may impair judgement or cause drowsiness, or if not otherwise medically fit to operate the equipment.

Remember correct working methods and avoid leaving the driver’s seat unnecessarily.
6.2 Use
The Bale forks are intended to be used for
lifting and transporting bales together with
AVANT loader.
Pick up the bale to be transported and set
the Bale fork to transport position by lifting
it slightly off the ground and tilting it slightly
up with the loader, as shown in the
adjacent figure.
The bale can then be transported with the
loader and left to a suitable place.

Always drive slowly while operating the Bale fork. Adjust the drive speed according to the operating
conditions and the ground.

If your loader is equipped with a telescopic boom, you can utilize it for a better visibility to the working
area.
Avoid sharp turns while handling heavy loads.