15 (22)
6.1
Checks before use
Check that the rear support guard is set to hisgh position and locked with both pins.
Make sure the adjustable fork is positively locked.
Ensure that bystanders are at a safe distance when operating the equipment. Do not let anyone to
enter danger area of the boom or to stay directly in front of the loader. Also make sure that it is safe to
reverse with the loader. Never assume that bystanders will remain where you last saw them;
especially children are often attracted to the moving equipment.
Check the general condition of the attachment and the loader, and check for possible hydraulic oil
leaks. The attachment must not be used, if there is a fault in the hydraulic system of the loader or the
attachment. Refer to Chapter 7 for maintenance instructions.
Operate the attachment and the controls of the loader only when seated on the driver’s seat. Ensure
that the loader and the attachment are used in a safe manner and as intended. Do not allow children
to operate the equipment.
Never operate the loader or attachments while under the influence of alcohol, drugs, medication that
may impair judgement or cause drowsiness, or if not otherwise medically fit to operate the equipment.
Remember correct working methods and avoid leaving the driver’s seat unnecessarily.
6.2
Use
The Bale handler is intended to be used for
lifting and transporting bales together with
AVANT loader.
Pick up the bale to be transported and set
the Bale handler to transport position by
lifting it slightly off the ground and tilting it
slightly up with the loader, as shown in the
adjacent figure.
The bale can then be transported with the
loader and left to a suitable place.
Always drive slowly while operating the Bale handler. Adjust the drive speed according to the
operating conditions and the ground.
If your loader is equipped with a telescopic boom, you can utilize it for a better visibility to the working
area.
Avoid sharp turns while handling heavy loads.