8(12)
6.1.
Use
The edge trimmer is started by turning the working hydraulics valve to its locked position. Depending on the
loader model, the working hydraulics control device is a lever that is locked in the front or right position, or a
pedal that is locked to lower position.
•
The edge trimmer is used with high engine rotations and depending on the model of the loader and the
trimmer, one or two hydraulic work pumps are used.
•
Adjust the drive speed according to the material being cut and the terrain.
•
If your loader is equipped with a telescopic boom, you can utilize that to see the working area better from
the loader.
Normally the edge trimmer should be operated when driving forward. Practise the use of the trimmer and the
controls of the loader in a safe area. If you are unfamiliar with the loader to be used, it is recommended to
practice its use without any attachments.
The hydraulic trimmer can be mounted on either side of the cutting disc. Mount the hydraulic hoses
according to the mounting point.
Before using the trimmer, check that the hydraulic motor is properly mounted on either
side of the cutting disc. Ensure that the hydraulic are fixed so that they are never
against the cutting disc.
Keep the protective bracket around the trimmer in its place. Note that regardless of the
bracket, rocks or cuttings may eject from the trimmer with high velocity. Stop the
trimmer, if there are persons less than 5 meters from the work site.
6.1.1.
Slope operation
Mowing on inclined terrains and slopes requires extra caution. Watch for holes, bumps, rocks and other
possible hidden obstacles. Uneven terrain could overturn the machine. Use low speed and do not make
sudden changes in speed or direction. Try driving straight up or down the hill, not across, to avoid excessive
side tilting. Exercise extreme caution when driving near ditches or embankments as the machine could
suddenly turn over if an edge caves in.
7.
Inspections, maintenance and servicing
Continuous maintenance of the edge trimmer includes monitoring the condition of the blades as well as
regular cleaning and lubrication of the equipment.
Ensure that the edge trimmer is properly supported during all inspection and
maintenance procedures. All maintenance procedures must be performed with the
loader engine shut down and the hydraulic hoses disconnected.
Check the condition of the hydraulic hoses and components when the engine has been turned off and the
pressure has been relieved. Repair all leaks immediately after detecting them; a small leak can quickly grow
into a big one. Do not use the equipment, if you have discovered a fault in the hydraulic system. Leaking
hydraulic fluid may penetrate the skin and cause serious injuries. Hydraulic fluid is also harmful to the
environment.