AVANT A21029, Инструкция по эксплуатации

Страница: 16 / 41

INSTALLATION INSTRUCTIONS
The firewood machine should be placed by the log pile to be sawn and chopped so that passages and the
working site by the machine are free. Check before starting the machine that all the fastening screws are tight
and that all the guards are in their proper places. Before commencing the work, check also that the machine
is firmly located. Clean the chainsaw, check its condition and ensure it is sound before starting the machine.
Check also the condition of the control and safety equipment before the start-up, and if there are faults,
rectify them before you start the machine.
U-J SHAFT DRIVE:
In U-J shaft driven installation the firewood machine is first fastened to the tractor 3-point linkage. It is then
centred and locked with the linkage stabilizer bars. The length of the UJ shaft must be checked. Note also
that machine end of U-J shaft protective guard must extend at least 50 mm over the shaft (Attachment: U-J
shaft instruction E3806-3). A non-contact check must be carried out when raising the 3-point linkage to its up
most position. Shorten the U-J shaft if necessary. The speed of the U-J shaft must not exceed 400 r.p.m. For
safety reasons this speed must not be exceeded. When the U-J shaft is not coupled to the tractor, it can be
lifted onto holding bracket by the machine side.
Tractor:
- The machine drive input is coupled to the tractor PTO shaft by means of a U-J shaft, and the
machine itself is supported by the tractor 3-point linkage. The U-J shaft can only be coupled when
the tractor PTO clutch is disengaged. Never allow the uncoupling of the U-J shaft relying only on
the disengagement of the PTO clutch.
- When starting the tractor engine, the PTO shaft must be disengaged.
- Before engaging the PTO shaft clutch, make sure that there is nobody within the danger zone.
- Always use the correct PTO speed. The PTO shaft must be disengaged when not in use.
- U-J shaft:
- Before engaging the PTO shaft and during the PTO use, make sure that there is nobody within the
danger zone.
- Never use anything else except a fault free, protected and approved U-J shaft.
- If a U-J shaft needs to be shortened, follow the manufacturer's instructions.
- In an installed U-J shaft, the locking pin must be inserted and locked in the locking groove on the
driven shaft. Check that the shaft is securely in its proper position and locked.
- Connect the shaft guard security chain so that the guard cannot rotate.
- For the uncoupled U-J shaft there is support bracket by the machine side. Never hang the shaft
from its security chain.
ELECTRIC MOTOR DRIVE:
- As an electric motor driven version the machine is equipped with a 400 V, 7.5 kW electric motor,
which can be connected up a power source by means of a 32 Amp, 5-pin extension cable. The
machine is equipped with an emergency stop system. Check that the direction of the rotation is
correct.
- If the motor runs the wrong way around, stop it immediately, remove the plug from socket, change
the two phase wires around and try again (leave the electric installations to an authorized
electrician).
TRANSPORT
The machine in available with lighter (K) and with more massive (R) axles. With K-axle maximum transport
speed is 60km/h and with R-axles 80km/h. If the machine is transported on public road it needs to be
equipped with lights and ‘maximum speed’ –
sticker. Also other legislations may be set in each country, check
the local regulations.
SUPPORRT LEGS
(B1,B2)
- Take off the holder clamp, lover leg down
- Put the holder back
ADJUSTING THE LENGTH OF LOGS
(B3)
- Loosen the fastener of stopper, choose right length, fasten stopper.