AVANT 650, Руководство оператора для насадки

Страница: 25 / 34

25 (34)
7.2.1 Operator qualification
Anyone who intends to use the attachment must:

Know the intended use of the attachment.

Know how to use the loader safely in different operating conditions.

Read and always follow the instructions concerning the use of the attachment in this operator's
manual.

Have this manual and the operator's manual of the loader available.

Ensure that the loader and the attachment are used in a safe manner and as intended.

Never allow children to operate the equipment.

Never operate the loader or attachments while under the influence of alcohol, drugs, medication that
may impair judgement or cause drowsiness, or if not otherwise medically fit to operate the equipment.

Complete any possible mandatory training required by the employer before use.
7.3 Operation
7.3.1 Using the log splitter
WARNING
Risk of serious personal injuries - Ensure that there are no other persons near the
operating area.
Do not allow others closer than 10 metres form the splitter, to the boom
danger area, or directly in front or back of the loader. Move carefully and calmly near
persons or farm animals. Also make sure that it is safe to reverse with the loader.
Setting up the Log splitter
1.
Choose a level working site, which can carry the load of the equipment and the logs. Clear the area
from any obstacles that could cause a tripping hazard. The working area must not be slippery.
2.
Operate the Log splitter in daylight or good artificial light and only in well-ventilated areas.
Activating and deactivating the log splitter:
1.
Make sure the log splitter is set to the working position, as described in this
manual.
2.
Adjust loader engine rpm so that hydraulic oil flow is within the recommended
range 15 - 25 l/min. Never exceed the maximum hydraulic oil flow 30 l/min.
Depending on the loader model, two hydraulic pumps may be used to reduce engine noise. Note that unnecessarily
high engine rotating speed will not improve the splitting force.
3.
Move the auxiliary hydraulics control lever to its locking position to start
hydraulic oil flow to the log splitter.
Release the auxiliary hydraulics lever to neutral position, and follow the safe
stopping procedure whenever the log splitter is not actively used.