525 LPG
Operating instructions
17
1
2
3
Suspension seat
The suspension seat is equipped with a seat belt and
has the following adjustments:
1. Suspension adjustment
by turning the lever clockwise suspension gets
harder, by turning it counterclockwise the
suspension gets softer
2. Angle of the back rest
the angle of the back rest can be adjusted by
pulling the lever
3. Seat position
the distance of the seat from the steering wheel
can be adjusted with the lever which is located
under the front edge of the seat
Suspension seat can be equipped with a seat belt.
Telescopic boom (option)
Telescopic boom is operated
either with the conventional
control lever, or with the
rocker switch on the joystick.
Length of the telescope is 600
mm and additional lifting height
is 485 mm.
Location of battery
disconnect switch
The loader is equipped with
a battery disconnect switch.
The switch is located in the
rear of the machine, on the
right side (see picture).
Battery disconnect switch
cuts the current between
battery and the rest of the
electric system. Always switch
off main current when the
loader is not used for a longer
period of time, or when
servicing the machine. Switch off the main current in
order that the battery doesnt get empty.
Boom self levelling (option)
Self levelling system keeps the
position of the attachment
the same in relation to the
ground, regardless of the
position of the boom.
Self levelling is hydraulic: there
is a levelling cylinder on the
left side of the boom which
follows the movements of the
bucket tilt cylinder and keeps
the attachment level.
Self levelling is disabled when
the boom floating is switched
on.
Boom floating (option)
The floating system releases the lift cylinder, so that
the boom floats upwards from the position where it
is when boom floating is switched on, allowing the
attachment to follow the contours of the terrain.
1. Lower the boom down
2. Switch on the floating with
rocker switch no.
3. Boom floating indicator on
the dashboard
lights up
When boom floating is being
used, it is possible that air gets
in the hydraulic system. This can lead to inaccurate
boom movements and the boom can give in. Therefore
the boom and attachment coupling plate should always
be moved to extreme end positions after switching
off boom floating. Use boom floating only when
necessary.
