AVANT 415430, Руководство оператора

Страница: 8 / 10

8(10)
6. Instructions for use
Check the attachment and the operating area before beginning work. Quick inspection of the attachment
before starting to use it is part of ensuring safety and the best performance of the equipment. Practise the
use of the spreader in an open and safe area. If you are unfamiliar with the loader to be used, it is
recommended to practice its use without any attachments.
6.1. Inspections before use
■
Check the wheels, clutches, and the general condition of the spreader before each day of
use. Refer to Chapter 7 for maintenance instructions and see the instructions regarding the
loader from the operator’s manual of the loader.
■
Before each use, check the operation of the broom and ensure that the spreader shaft can
rotate freely. Check that there is no string or other foreign material coiled around the shaft.
■
Check that the contact surfaces of the clutches on the wheel rims are clean and lubricated. If
the surface is dirty or not greased, see Chapter 7 for maintenance instructions.
6.2. Using the spreader
Ensure that the loader and the attachment are used in a safe and intended manner.
Operate the attachment only when sitting on the driver's seat. Do not allow children to
operate the machine.
Operate the controls of the loader carefully and calmly during operating the equipment.
Drive slowly especially on slippery surfaces.
Controlling the spreading
:
The spreader can be set to roll freely with the clutches on the
wheels (A). When the free running mode is needed, set the
locking pins to pulled position.
Make sure that both clutches are set
similarly to avoid overloading a single
pin.
Adjusting the spreading rate:
The amount that the spreader spreads at each rotation of wheels depends on the size of the spreaded
material and of the position of the doser adjustment plate. The spreader will spread more material when the
doser plate adjustment nut is tightened.
NOTICE
A
Figure 6 – Wheel clutch pins