6(8)
Do not use the automatic return of the locking pins when the attachment or the boom
has been lifted at a height of over one metre. Excess tilting increases the risk of
toppling over. We recommend that you lower the attachment onto the ground and
secure the locking manually.
Ensure the stability of the attachment when taking it off from the loader. Set the
outriggers so that the bucket will not tip over. Read the instructions in section 6.
The automatic returning of the locking pins is an useful feature, when attaching an empty attachment at low
height and on even surfaces. Otherwise we recommend to lock the pins manually.
6.
Instructions for use
The skip bucket will stay in place with its two outriggers. Place the outriggers so that they will not get bent or
damaged when mounting the bucket or taking it from the loader.
Make sure that the skip bucket is
properly supported; tilt the outriggers
fully and lower the bucket on a even
surface.
The skip buckets may be filled completely, if the loader can handle the total load. Check the load handling
capacity of the loader from the diagram in the operator’s manual of the loader.
Lifting material from a pile requires the most power from the loader. Especially when using a bucket with a
long base, the correct working method should be observed for the best performance of equipment. Filling
the large bucket by ramming straight into a pile of heavy material and then trying to lift or tilt the bucket is not
possible with any loader type. The loading is most effective when only the tip of the bucket is pushed into the
pile, and then by simultaneous driving, lifting and tilting the equipment, material is cut into the bucket. Use
high engine revolutions and read the instructions for correct use of the drive pedal from the loader manual.
In case the loader is not equipped with the boom self levelling:
When lifting the bucket to a high level, the front plate must be simultaneously tilted to
prevent the load from falling from on the loader or the operator. Fitting the loader with
the boom self-levelling option makes the repeated lifting work easier.
7.
Maintenance and servicing
Do not let water to stay in the bucket. You may use a pressure washer and a mild detergent to clean the
bucket. Do not use strong solvents or spray directly at the labels on the attachment. For longer storage
periods touch up the paint where needed to prevent rust damage. Do not store the attachment directly
against the ground; place it on blocks of wood or on a pallet, for example. Preferably store the bucket so that
is laid on its long base and not left on its outriggers
Содержание 300-700 Series
Страница 8: ......
