1. Use mild liquid detergent and soft cloth for daily cleaning. Do not use a detergent with acetone
or ammonia. Disinfector with formic acid and formaldehyde is forbidden during disinfection.
2. Screw of the water circulation and jets for cleaning when plug up by litter such as hair.
3. If there is a scratch on the bathtub surface, please use 2000# waterproof abrasive paper to
polish it, put a bit of toothpaste before doing it. After that, use cloth to polish it.
4. Stone and stains can be wiped off by warm citric acid egg. Lemon juice or vinegar with a soft
cloth.
5. Do not clean the bathtub with hard or coarse material to avoid any scratches, as well as with
chemical solvent to avoid any damages.
6. Be sure to drain the water off and disconnect the power supply after each use.
7. Do not hit and score the bathtub by hard or keen-edged material. Do not touch the bathtub by
cigarettes ends or any heating source over 70C degrees.
8. Water massage cleaning system: fill in the bathtub with 40C of hot water, add detergent (2g/L).
Then run the water massage system for 5 minutes. After that stop the pump and drain it off. Fill
the bathtub with cold water and run the massage system for 3 minutes. Finally clean the bathtub
one more time after stopping the pump and draining off the water.
Precautions
1. The installation should be carried out by a qualified technician and should be done according to
the manual.
2. The bathtub electric parameter should be equivalent with the National Safety Standards. There
should be electric leakage protector on the power supply. Make sure the ground wire is safe.
Protect the switch, electrical outlet and plug from water.
3. Do not put very hot water directly in the start of your bath, please start with cold water, after
that, switch it to warm. Do not turn on the massage option until the water level is high enough
to cover the jets.
4. The rated voltage of this bathtub is 220V. Do not run it when the voltage is over 235V or under
190V.
5. Disconnect from power supply after each use.
6. Taking a bath for more than 30 min may be harmful to your health.
7. Please restart the bathtub for occasional problems with the system.
8. If the supply core is damaged it must be replaced by the manufacturer, service agent or similarly
qualified person in order to avoid hazard.
9. This manual is attached with the product, please read it carefully before the installation. Usage
of this bathtub should be according to this manual to avoid damage or other accidents.
Usage of the Product
10
