4
Application
Filling your Kettle
1. Ensure that the Kettle is lifted off the base before filling.
2. To fill the kettle, open the cover by lifting the lid.
3. Fill to the desired level (Min 0.8 L~Max.1.8L)
4. Close the lid by pressing it down until it clicks into place.
Switching On/Off
1. Connect the Plug to a 240V power point.
2. To switch on the kettle, press the On/Off switch downwards. The power indicator light will then turn on.
3. When the water has boiled the kettle will automatically switch itself off.
4. You can halt the boiling process at any time by turning the Kettle off by flicking the On/Off switch. The
power indicator light will then turn off.
Cleaning and Maintenance
First read the instructions in the section titled “SAFETY WARNINGS”.
Avoid using abrasive cleaning agents.
Descaling
For normal use, descale the kettle at least twice a year by following the procedure below:
TO CLEAN THE INSIDE OF THE KETTLE:
1. Use a kettle de-scaling solution available from most supermarkets or household suppliers, OR
2. Half fill the kettle with tap water and add the juice of 1 lemon to the water.
3. Boil this mixture and allow it to stand for 15 minutes. Re-boil the mixture and allow it to stand for a further
15 minutes. Re-boil this mixture a third time and rinse the kettle well.
This procedure may need to be repeated in extreme cases. Abrasive cleaners MUST NOT be used as this can
damage the stainless steel finish.
Troubleshooting
Problem
Solution
The unit is will not turn on.
Check that the base is connected to a working
wall socket and that the power is on.
Check the kettle is correctly positioned on the
base
Check that the switch stays in the on position once
pressed.
The kettle is leaking
Ensure it has not be overfilled.
Completely dry the kettle, and leave overnight –
preferably in an upside down position so water
