8
www.avalon-bay.com
A
SSEMBLY
&
I
NSTALLATION
Remove the exterior and interior packaging. Check to ensure all parts
are included:
6 shelves
1 handle with 2 screws
1 owner’s manual
If any parts are missing, please contact the dealer where you purchased
the unit or Avalon Bay customer service.
Handle Assembly
Before installation, attach the handle to the front of the unit with the
included screws. It may be necessary to push aside the rubber seal on
the inside of the door to reveal the screw holes. Avoid over-tightening
the screws, or you may cause damage to the unit.
Installation
1.
Clean the interior surface with lukewarm water using a soft cloth.
2.
Place your wine cooler on a surface that is strong enough to support
the appliance when it is fully loaded. To level your cooler, adjust the
front legs at the bottom of the appliance.
3.
For proper ventilation, allow at least 2 inch clearance between the
back of the unit and any adjacent walls
4.
For best results, install away from direct sunlight and sources of
heat (stove, heater, radiator, etc.). Direct sunlight may affect the
acrylic coating and heat sources may increase electrical
consumption. Extreme cold or hot ambient temperatures may also
cause the cooler not to perform properly.
5.
This cooler is not designed for placement in attic or basement. The
appliance is for indoor use only.
