Avallon AIMG151GPRI, Руководство пользователя

Страница: 12 / 28

12
Leveling the Ice Maker
The ice maker should be installed on a firm and level surface that will be
able to support the entire weight of a fully loaded unit. It is important
for the ice maker to be leveled in order to work properly. It can be
raised or lowered by rotating the feet on the bottom of the machine. If
you find that the surface is not level, rotate the feet until the ice maker
becomes level. You may need to make several adjustments to level it.
We recommend using a carpenter’s level to check the machine. Turn
the leveling feet to the right to lower that side of the ice maker. Turn the
leveling feet to the left to raise that side of the ice maker.
Important: Once you are ready to install the unit in a cabinet or directly on the floor, you must
adjust the feet to level the ice maker.
!
Installing the Door Handle
Caution: Do not over-tighten the screws as this may cause damage to the handle or to the door.
!
To install the door handle:
1. Open the door and carefully pull out the section of the door gasket that covers the hole where the handle
is to be installed.
2. Insert each Phillips head screw through the hole on the inside of the door until the screw passes through to
the outside of the door.
3. Align the handle with the screws and tighten using a Phillips head screwdriver until the handle is flush
against the door frame.
4. Carefully press the door gasket back into its original position.
Down Up
Note: Panel ready models allow for the installation of different handles, which may be affixed to
the panel overlay directly. Door handle installation may be different than the above instructions.