AV TOOL AVT-5841, Инструкция по эксплуатации

Страница: 8 / 10

8
5.1 Standard Operation
Press the button on the extreme right of the front panel to manually select the
desired input. This button is called the SELECT/LEARN switch and the ‘Learn’
function will be explained in a moment.
5.2 Remote Control Operation
Note: there is no intervention by the AVT-5841 to determine if the selected signal
is valid. The unit will route the selected input to the output even if there is no
signal present or the selected signal is noisy. (The same is true for the Audio
signals).
5.2 Using Another Remote Control Device
You can use a third party Infrared controller to cause the AVT-5841 to select an
input. To do so, it will be necessary to ‘teach’ the AVT-5841 the association you
wish to create between the third party remote and a particular input selection. (In
other words, you will teach the AVT-5841 to switch to a particular device any time
you use the remote control for that device.)
Press and hold the ‘LEARN’ button for > 4 seconds. The LED associated with
Input 1 will flash. Press a button on the third party remote you wish to be
associated with input 1 – for instance, if your DVD was connected to input 1, you
would use the remote for your DVD player. The LED for input 1 will now go off
and any time in the future you use your DVD remote, the AVT-5841 will
automatically switch to the input for the DVD. Repeat the procedure with other
remotes for the remaining three inputs if you wish to automatically select
associated inputs for those inputs.
6.0 Troubleshooting
Make sure the AVT-5841 is connected to a known good monitor and the desired
inputs are present. If one input image is acceptable but others are not, you
should suspect faulty ca bles. Swap the cables to determine if the problem moves
with the cable(s).
Using the included remote control, select the
desired input. If appropriate input signals have
been connected, you will see the selected input
appear on your monitor or projector.