Distribution Amplifier (DA)
—
User Manual
11
LAN Port:
Use the RJ45 connection cable to connect the Internet and the Distribution
Amplifier (DA). The entire PCs at the same network can control the Distribution
Amplifier (DA) through the LAN port. Refer to
6.6.3 LAN Port
.
Switchers:
Distribution Amplifier (DA) supports 8 pins DIP and 2 pins DIP switchers for
connected configurations. For more information, refer to
6.6 Ports and Switchers
.
-
Pin 1~Pin5: ID
-
Pin 6: Master/Slave
-
Pin 7: RS-232/LAN
-
Pin 8: IP RESET
IR EXT:
This is used to connect the IR Receiver cable for the Distribution Amplifier (DA)
Remote Controller. Refer to
6.3 IR EXT Connection
.
INPUT:
Distribution Amplifier (DA) Input jack is connected to the Blu-ray player, DVD
player, STB or other source device.
HDMI Type A: Pin Definitions:
Pin #
Signal
Pin #
Signal
1
TMDS Data2+
11
TMDS Clock Shield
2
TMDS Data2 Shield
12
TMDS Clock-
3
TMDS Data2-
13
CEC (NC on device)
4
TMDS Data1+
14
Utility (NC on device)
5
TMDS Data1 Shield
15
DDC-SCL
6 TMDS
Data1-
16 DDC-SDA
7 TMDS
Data0+
17 DDC-Ground
8
TMDS Data0 Shield
18
+5V Power
9
TMDS Data0-
19
Hot Plug Detect
10 TMDS
Clock+
OUTPUT1~8 or 16:
Distribution Amplifier (DA) Output jacks are connected to
extensible accessory devices (HX-RW) for HDTVs, projectors or other sink devices
connections.
)
OUTPUT1~8 or 16 RJ45 jacks are only used for HDMI Extender connections.
IR Tx Port:
Used to connect to the IR Blaster cable for IR pass-through.
IR Blaster Pin Definitions:
IR Rx Port
: Used to connect to the IR Receiver cable for IR pass-through.
IR Receiver Pin Definitions:
