Autotek ATX1000.2, Руководство пользователя

Страница: 8 / 15

FULL RANGE
STEREO LINE INPUT
NOT USED
Y-ADAPTOR
Note: You can use the Radio/CD designated mono line output
or a full range stereo line output. For full range stereo line output,
you will need an optional “Y-Adaptor” as shown
PARALLEL MONO
SUBWOOFERS
2- OHMS EACH MINIMUM
GND REM +12V
POWER INPUT FUSE
SPEAKER OUTPUT
+ + - -
6
ATX2000.1 / MONO AMPLIFIER APPLICATIONS
Basic application
SUBSONIC:15 Hz to 55 Hz These sub bass amplifiers can be used in any of the bi-amplification systems
BASS EQ: 0 to +12dB described in this manual, replacing the 2 channel amplifiers as per the
illustrations.
Level control checklist:
“Setting up systems after installation for best performance” Interconnect cable checklist: Refer to the section
Connect the inputs to a suitable source, e.g. a head unit with good quality RCA
cables. Connect the LINE OUT to the inputs of the system highs amplifier.
Minimum final loudspeaker impedance: 1-Ohm.
Use at least #12 gauge speaker wiring. The amps have dual speaker terminals,
simplifying the hookup of multiple speakers
Crossover frequency control checklist:
LOW PASS: 40Hz to 150Hz
GND REM +12V
POWER INPUT FUSE
SPEAKER OUTPUT
+ + - -
OUTPUT INPUT
BASS SUB LOW
REMOTE CONTROL
POWER
PROTECT
R R L
L
0dB 12dB 15Hz 55Hz 40Hz 150Hz 6V 0.2V
BOOST SONIC P
ASS LEVEL
REMOTE TURN-ON
CHASSIS GROUND
TO B12 Volts VIA FUSE
DESIGNATED MONO
OUTPUT FROM HEAD UNIT
MONO
SUBWOOFER
utotek
a
0dB 18dB
ATR-1