A
U
T
O
T
E
C
H
Installation Instructions
Phone 714.240.4000 Fax 714.240.0450
32240-E Paseo Adelanto, San Juan Capistrano, CA 92675
Part Number:
10.215.455K
Description:
Sport Tuned Boost Check Valve
Procedure:
1.
Open hood and locate the air hose leading from the idle stabilizer to the bypass tube.
2.
Measure 1 1/4" from the idle stabilizer end of the hose and mark. Next, make another
mark 5" from the same starting point.
3.
Cut the hose at both marks, and remove the 3 1/4" section of hose that has just been
cut out. The boost check valve will replace the section of hose that you have just cut out.
4.
Loosen the hose clamps a little and place them over the hose at both ends. Insert the
boost check valve into both ends of the hose,
with the arrow on the check valve body point-
ing towards the idle stabilizer.
5.
Slide both hose clamps over the hose, approximately 1/4" away from the flats on the
black anodized ends of the check valve. Tighten both hose clamps.
5"
Mark and Cut
3 1/4"
1 1/4"
Remove This Piece
á
