P. 4
User
Guide
Example:
If the multi-level features were set to option 3, the setup would be as follows:
x
Level 1
Æ
Customized feature
x
Level 2
Æ
Multi car operation
x
Level 3
Æ
Basic
features
The
“Basic features”
are now programmed as level 3 and therefore:
x
To access
cold weather mode
, the user needs to press on the
PANIC/AUX
button
three
(3) times
followed by the
START/STOP
button.
Remote-Starting Your Vehicle
Press the
START/STOP
button for approx. 1 second. The parking lights will come on
to inform you
that the remote starter has received your signal. Approximately 5 seconds later, the engine will
start. The parking lights will remain on
during the pre-programmed run time of the engine.
If the vehicle does not start at the first attempt, the system will shut down, wait a few seconds and
try to start the engine again. There will be 3 start attempts before the system gives up.
Vehicle Presets
Heater & Heated Seat
When leaving the vehicle it is recommended to preset the accessory controls in preparation for the
next remote start. Settings for the blower motor (fan), front and rear, as well as heated seats (if
equipped) should not be left on
HIGH
. It is recommended to leave the settings on
LOW
or
MEDIUM
instead.
Windshield Wipers & Radio & Headlights
Certain vehicles require the radio and / or windshield wiper and / or headlight circuits to become
energized while running under remote start. When leaving the vehicle you must ensure that the
windshield wiper and headlight switches are off. Leaving the headlight switch on
on certain types of
vehicles could cause them to remain on
even after remote starter shut down, resulting in a dead
battery.
Driving Off
With the vehicle running under remote control, press the
UNLOCK
button to disarm and unlock the
doors. Enter the vehicle and do the following:
Turn the ignition key to the
IGNITION ON (RUN)
position. (
Do not turn the key
to the
CRANK
position
while the engine is running. This would cause the starter motor to re-engage.)
Press the brake pedal to disengage the remote starter unit.
You are now ready to drive off.
Using the Remote Starter
Arming the Starter Kill
The starter kill (if installed) can be configured by the installer so as to arm automatically (passive
mode) or not to arm automatically (active mode). See section
passive or active arming
on p. 7 for
more details on passive mode and active mode.
•
To
disarm
the starter kill, press the
UNLOCK
button on the transmitter.
The parking lights will flash twice.
If remote door locks are installed, this will also unlock the doors.
•
To
arm
the Starter Kill, press the
LOCK
button on the transmitter.
The parking lights will flash once.
If remote door locks are installed, this will also lock the doors.
•
In
passive mode
, the starter kill will automatically arm if the ignition key is not inserted
Into the ignition switch within 1 or 3 minutes after unlocking (the key sense feature
must be installed).
