AS-1725 SH
Installation Guide
P. 11
To program a Transmitter
on the second vehicle for Multi-car Operation, you must press
the
TRUNK
and
LOCK
buttons simultaneously (instead of
LOCK
or
UNLOCK
) in step 2 of the
Transmitter code-learning procedure:
Entering Programming Options Mode
The Remote Car Starter is equipped with three custom programming Modes that allow the
installer to custom-fit the system outputs according to installation requirements. The
Programming Options are designed to facilitate interfacing with all vehicle types. (See
section
Table of Programming Options
later in this Guide.)
1.
Flash the Hood Pin switch (see Table 1)
– The Parking Lights will stay
ON
for up to 20 seconds.
– Before the lights go out:
2. Press and hold the Brake Pedal,
– And press one of the following buttons on the Transmitter:
x
LOCK
..................to access Mode 1;
x
UNLOCK
..............to access Mode 2;
x
TRUNK
................to access Mode 3.
The
Parking Lights
will
flash
and the
Horn
will honk once, twice or three times to
confirm entry into a Mode.
3. Release the Brake Pedal.
Table 3: Accessing modes
Note
The Unit will stay in the selected programming
Mode until the Hood Pin-switch or the Brake Pedal
is pressed again.
Therefore take your time to
make the proper selection.
Pressing the Brake
Pedal will take you back to the Programming
Centre, where you can select a different Mode.
Once you access a particular programming Mode, you will automatically start at Function 1.
Once you select one of the Options of Function 1, you will automatically be taken to the next
Function.
To select one of the four Options
of any given Function, press the corresponding button
on the Transmitter:
x
LOCK
button ......................................to access Option 1
x
UNLOCK
button ..................................to access Option 2
x
TRUNK
button ....................................to access Option 3
x
START
button .....................................to access Option 4
Table 4: Accessing options
In each Function, once an Option has been selected the Parking Lights will flash 1, 2, 3 or 4
times (depending on the selected Option).
Please note
that the different Functions within any particular Mode can only be accessed
sequentially: the Programming Centre will move from Function 1 to Function 2, then to
Function 3, and so on. Therefore, whenever you access a particular Mode, be prepared to
re-configure all the Functions of that Mode in ascending order.
