P. 6
User Guide
Remote Door Locks
If your system was installed with the Remote Door Locks option, you will have the
convenience of remote keyless entry.
To
LOCK
your doors and
ARM
the Starter Kill:
1.
Press and hold the
LOCK
button for approx. 1 sec.
2.
The parking lights will flash once and the L.E.D. will flash slowly to confirm that the
doors have been locked and that the Starter Kill feature is enabled if it was installed.
To
UNLOCK
your doors and
DISARM
the Starter Kill:
1.
Press and hold the
UNLOCK
button for approx. 1 sec.
2.
The parking lights will flash twice and the L.E.D. will go out to confirm that the doors
have been unlocked and that the Starter Kill feature is disarmed if it was installed.
Note:
If installed and configured in Passive Mode at installation, the Starter Kill feature will
rearm automatically 60 seconds after the doors are unlocked. For that reason, you may
have to unlock your doors a second time if some time elapses before you actually start
the engine.
Ignition-controlled Door Locks Option
This is an added security feature. If your system was installed with the Ignition-controlled
Door Locks option, the doors will automatically be locked as soon as the user presses the
brakes while the ignition key is in the
IGNITION ON (RUN)
position.
When the key is turned to the Ignition
OFF
position, the doors will automatically be unlocked.
(Only available if remote Door Lock Option is installed)
Secure Lock Option
Before it can remote-start your vehicle, the module must first disarm the factory security
system.
The Secure Lock feature may be required on certain vehicle models with factory security
systems that automatically unlock the doors when the security system is disarmed.
To keep your vehicle protected when the factory security system is disarmed for a remote
start, Secure Lock will relock your doors as soon as the vehicle has started.
Once the engine run cycle ends, Secure Lock will rearm your factory security system.
Remote Trunk Release Option
If your system was installed with the Remote Trunk Release, you can open your trunk by
pressing the
TRUNK
button on the remote transmitter. Vehicles must have an electric
TRUNK
switch or a remote
TRUNK
button on the vehicle’s OEM Transmitter for this option to be
compatible with the Module.
Turbo Mode
If Turbo Mode is configured at installation, it will allow a turbocharger to idle down after the
user leaves the vehicle: the unit will take over the vehicle and keep it running for 60 seconds
(or until it is shut down by remote control), then shut down the engine and set the Remote
Car Starter to Ready Mode.
To activate Turbo Mode, follow all steps of the Ready Mode routine :
1.
Ensure that all the doors are closed and that the shifter is in the neutral position.
2.
With the engine already running, apply the parking brake and release the brake pedal.
Make sure to release the brake pedal.
3.
Within 20 sec. press
LOCK
,
UNLOCK
or
START/STOP
on the transmitter.
The parking lights will flash 3 times quickly and remain lit.
4.
Remove the key: the engine will go on running.
5.
Exit the vehicle and close the door.
6.
Press and hold either:
a)
LOCK
to lock the doors and shut down the engine after 60 sec.;
