Introduction
This Module is a state-of-the-art remote car starter system. With many advanced function,
this product will satisfy any one of the user’s expectations from high-end commodity systems,
without neglecting the standard features commonly offered by entry-level starters.
Basic Remote Operation
Your remote car starter can operate two independent vehicles equipped with an identical
remote car starter (see multi-car operation on page 6).
The functions of the transmitter are as follows:
Pressing the
LOCK
and
UNLOCK
buttons simultaneously will activate the
AUX 2
output.
Remote-starting Your Vehicle
Press the
START/STOP
button for approx. 1 second. The parking lights will come
ON
, informing
you that the unit has received your signal. Approx. 5 seconds later, the engine will start. The
parking lights will remain
ON
during the pre-programmed run time.
If the vehicle doesn’t start the first time, the system will shut down, wait a few seconds, and
try to start the engine again. It will try to start the engine 3 times before giving up.
Setting the system to Ready Mode
This unit is designed for Manual Transmissions only. In order to remote-start the vehicle, the
Unit must first be set to Ready mode. If the Unit is not set to Ready Mode, it cannot remote-
start the vehicle. Once the system has been set to Ready Mode, the vehicle can be remote
started and stopped at will (as long as the Unit never exits Ready Mode).
1.
Ensure that all the Doors are closed and that the Gear Lever is in the Neutral
position.
2.
With the Engine already running, apply the Parking Brake.
3.
Within 20 sec. press
LOCK, UNLOCK
or
START/STOP
on the Transmitter.
The Parking Lights will flash 3 times quickly and remain lit.
4.
Remove the key: the Engine will go on running.
5.
Exit the vehicle and close the Door.
6.
Press either:
a.
LOCK
to lock the Doors, arm the Alarm and shut down the Engine;
b.
UNLOCK
to unlock the Doors and shut down the Engine;
c.
START/STOP
to shut down the Engine without affecting the Doors or;
d.
TRUNK
to lock all Doors and engage idle mode.
P. 2
User Guide
AS-1474/AS-1484
