P. 14
User
Guide
Diagnostics – Parking Light Flash Table
Flashes
Description
1
•
Doors locked, starter kill armed
•
End of run time
•
TRUNK
button pressed
•
Start signal received by the module
•
Cold weather mode cancelled
2
•
Doors unlocked, starter kill disarmed
•
Run time cancelled
•
Remote start attempt cancelled by remote
•
Exiting remote valet
•
Exiting ignition valet
3
•
Entering cold weather mode.
•
Entering extended run time.
•
Entering remote valet
•
Entering ignition valet
4
•
+12 V where detected on the brake line and cranking was cancelled.
•
Entering tach-programming mode
5
•
New transmitter programmed.
•
Tach programmed.
6
•
A remote start was attempted while a tach or a vacuum signal was detected
before cranking.
8
•
Unit reset: occurs when the unit is reset to the factory defaults.
10
•
The hood switch line went to ground during cranking or run time.
1 – pause – 2
•
There was an attempt to start the vehicle while the module was in valet
mode.
ON solid
•
Cold weather mode: the brake pedal is being held down.
2 – pause – 2
•
There was an attempt to start the vehicle while the module was in home valet
mode.
ON 2 sec.
•
The hood is up and the hood switch line went to ground. This is step one of
the programming centre procedure.
ON 3 sec.
•
First press of the
START
button under safe start.
ON 4 sec.
•
Locking or unlocking a door (with door pulses configured to 4 sec.)
ON 25 sec.
•
The hood pin-switch has been pressed twice: the unit went into step 1 of the
programming centre procedure, and no transmitter activity was detected for
20 seconds.
•
Or
the unit went into step 1 of the transmitter programming procedure and no
activity was detected for a few seconds. The unit has exited the transmitter
programming procedure.
Irregular
•
If the unit gives irregular signals (1 to 10 flashes followed by a pause,
followed by further flashes), the system is playing back start failure codes.
This occurs when the hood pin-switch is pressed three times
Constant
flashes
up to
25
sec.
•
Panic mode is triggered.