25
If the temperature sensor is active you can monitor, through the
LCD screen, the present indoor temperature of the passenger
compartment before cooling or heating your vehicle.
Press the transmitter
buttons and within 3 seconds press the
(
)
button. The in-door temperature will be shown on the LCD
screen. This reading may be higher than actual ambient
temperature due to the greenhouse effect and is relative only the
inside vehicle temperature.
G. TO TURN OFF THE REMOTE START:
When the engine is running (by remote start), if you want to stop it,
1. Press
button once on the remote transmitter while in the
remote start mode.
2. Press the brake pedal. The vehicle will shut down and turn off the
parking lights
will indicate engine has stopped
3. Move the optional remote start enable toggle switch to OFF
position. (If installed)
H. SHUT-DOWN INPUT FOR REMOTE STARTER:
If any of the following conditions exist while the system is operating, the
engine will not start or will shut down immediately:
1. The hood is opened.
2. The brake pedal is pressed.
3. Engine is over-revved. {“Tachometer checking type” only}
4. The pre-programmed run time (5 /10 / 20 / 30 minutes) has elapsed.
5.
Press
button once on the remote transmitter under remote start mode.
6. The optional remote start enable toggle switch is in the OFF position. (If
installed)
7. The vehicle refused to start running after {3} unsuccessful attempts.
I. DISABLING THE REMOTE START SYSTEM:
(Toggle switch If installed)
This feature allows your system’s remote start unit to be temporarily disabled
to prevent the vehicle from being remote started accidentally. This feature is
useful if the vehicle is being serviced or stored in an enclosed area. To disable
the remote start, move the optional remote start enable toggle switch to the
OFF position.
