C3RS1000 OP 3/08
17
1.Light impact will trigger the warn-away signal.
2.Heavy impacts / Doors open / Hood open / Trunk open / Turning on the ignition key will trigger the
programmed sequence.
The starter disable relay (if installed) prevents the vehicle’s starter from cranking. The siren, horn, parking
lights, and dome light will turn on to alert of an intrusion for 30 seconds. Then it will stop and automatically
reset and re-arm. If the sensors or detectors are still active, the alarm system will sound a maximum of 6
times of 30 seconds cycles.
Stop The Melody Sound:
While triggering the alarm
the OLED screen will alert user through melody
sound and flashing trigger icon, press any button on
the OLED remote transceiver to stop melody sound.
NOISE ABATEMENT CIRCUIT:
Your system has “Noise Abatement Circuit”. It can prevent annoying
repetitive trigger sequences due to faulty door pin switches or environmental condition such as thunder,
jackhammers, airport noise, etc.
Here’s how the “Noise Abatement Circuit” work s: If the alarm triggers five times, each time the same sensor
(zone 4) is triggered the “Noise Abatement Circuit” will interpret this pattern of triggers as false alarms. After
the fifth trigger, the “Noise Abatement Circuit” ignores, or bypasses that sensor until any other sensor or
switch is triggered.
“Noise Abatement Circuit” covers doors (Hood/Trunk) differently: If the alarm is triggered by an open door for
six full cycles, the doors will be bypassed until the trigger ceases.
M. ANTI CAR - JACKING (Programmable)
Warning:
If you do not need the car jacking function in this alarm system, be sure to set the car jacking
feature “OFF”. This systems default setting is car-jacking feature “OFF”.
ACTIVE ANTI CAR JACKING:
1. Spin up the
switch to the page
1
and then press and hold the “Car Jacking” button
for 2 seconds or press and hold the transmitter
and
buttons at the same time
for 2 seconds while the vehicle’s ignition is ON. The parking lights will turn on for 1.5
seconds to indicate the system has entered the car-jacking mode.
2. Once the system is in car-jacking mode and you are forced from the vehicle, the
system will be triggered when the door is opened and closed while the ignition is in
the “ON” position.
PASSIVE ANTI CAR- JACKING:
(Programmable)
1. Turn the ignition switch to the “ON” position. The system enters the car-jacking
mode.
2. Once the system is in car-jacking mode and you are forced from the vehicle, the
system will trigger when the door is opened and closed while the ignition is in the
“ON” position.
TRIGGER SEQUENCE OF THE ANTI CAR - JACKING MODE:
a). 50 seconds after the system has been triggered. The siren will start chirping for 15 seconds.
b). During this 15 second period of chirping, you will be alerted to push the valet switch once to turn off the
car-jacking feature. If not, it will enter the second timer of the car jacking sequence.
c). 65 seconds after the system has beer triggered the siren starts alarming and the parking lights will start
flashing.
d). 90 seconds after the system has beer triggered
1. The siren will still be alarming and the parking lights will continue flashing.
2. The starter disable will activate to prevent the vehicle from starting if stopped.
3. It will remain active until the vehicle's battery power is exhausted.
OVERRIDE THE SYSTEM TO TURN OFF ANTI CAR- JACKING:
Turn the ignition switch from OFF to ON and within 10 seconds push valet switch, the siren will stop and the
system will be disarmed
МSVMASTER - Установка и разблокировка охранных систем автомобилей -
http://www.msvmaster.lv
МSVMASTER - Установка и разблокировка охранных систем автомобилей -
http://www.msvmaster.lv
