225-1100-01 V1.5
Cadillac CTS Installation Sheet
Autonet Mobile Customer Service – 1-800-977-2107 or [email protected]
11
1
Installation Sheet
Safety Precautions
WARNING
To prevent injury or fire, take
the following precautions:
• To prevent a short circuit never put
or leave any metallic objects (such as
coins or metal tools) inside the unit.
• If the unit starts to emit smoke
or strange smells, disconnect
immediately and consult the Autonet
Mobile Customer Service Center.
• Do not touch the In-Car Router
during use because the surface of the
unit becomes hot and may cause burns
if touched.
• Mounting and wiring this product
requires skills and experience. For
safety’s sake, leave the mounting and
wiring work to professionals.
CAUTION
To prevent damage to the In-Car
Router, take the following
precautions:
• Be sure the In-Car Router is
connected to a 12v DC power supply
with a negative ground connection.
• Do not open the bottom covers of
the In-Car Router.
• Do not instal
l
the In-Car Router in a
spot exposed to direct sunlight or
excessive heat or humidity. Also avoid
places with too much
dust or the possibility of water splashing.
• When replacing a fuse, only use a
new one with the prescribed rating.
Using a fuse with the wrong rating may
cause your unit to malfunction.
• To prevent a short circuit when
replacing a fuse, first disconnect the
wiring harness.
NOTE
• If you experience problems during
installation, consult the Autonet
Mobile Customer Service Center.
• If the In-Car Router does not seem to
be working right, consult the Autonet
Mobile Customer Service Center.
Wiring
• Do not allow the wire to directly
contact the edge of the iron plate by
using grommets.
• Connect the ground wire to a metal
part of the car chassis that acts as an
electrical ground passing electricity to
the battery’s negative terminal. Do not
turn the power on if the ground wire is
not connected.
• Be sure to install the protective fuse
in the power cord.
Cleaning the In-Car Router
If the In-Car Router becomes dirty,
turn off the power and wipe the panel
with a dry silicone cloth or soft cloth.
Do not wipe the In-Car Router with a
hard cloth or a cloth dampened by
volatile solvents such as paint thinner
and alcohol. They can scratch the
surface of the In Car Router and/or
cause the sealant to peel off.
To prevent the battery from
draining please refrain from leaving
the key in the ACC on position. This
powers the In-Car Router up and could
possibly deplete the battery.