407: R-2: 06/20
Effective Date: Jun 2020
4.
Press and hold again either the left or the right programming button (3 or 4); the shade moves up until it reaches
your desired top limit; if it goes too fast/slow, you can release and press the same button (3 or 4) again to switch
to a slower/faster speed. Once you reach the top limit, release button (3 or 4). Now press and hold the ‘Save’
button (5) until the right LED light (2) comes ON, then release it.
5.
Now press and hold again the left or right programming button (3 or 4) and move the shade down until you reach
the desired bottom position, then press and hold the ‘Save’ button (5) until the right LED light (2) comes on. The
desired top and bottom shade positions have now been set.
6.
Release the Dash-Switch that you have been holding down all along.
7.
Disconnect the programmer from the white motor pig tail wire by holding the connectors and not the wires (see
Illustration above (A).
8.
Finally, check the end positions by operating the shade up and down by means of the dash switch.
Important Note:
The programmer needs to be disconnected after the programming process is finished. Never leave the programmer
connected to the motor!
