Smart Hub Set Up
Mounting the Hub
a. Determine whether you are going to wall mount the
hub.
i. If hub is to be placed on bench, simply connect to
power supply
2
, turn on and proceed to installing
the Transceiver.
ii. If hub is to be wall mounted follow steps below.
b. To wall mount - Use wall bracket
3
as template to
mark where to drill holes. Pre-drill holes.
i. For plaster walls - insert (2) two Plastic wall plugs
4
into holes, place wall bracket over holes and affix
with (2) two self tapping screws
5
.
ii. For brick walls - place wall bracket
3
over holes and
affix with (2) two self tapping screws
5
.
c. Slide the hub over the bracket.
d. Connect the power supply
2
and turn on.
1
3
5
This device must be connected to power at all times.
DO NOT disconnect power after setup.
Mounting the Transceiver to the Opener
a. Disconnect the power supply to the opener and open
the main cover.
b. Connect the harness
7
to ACC on the control board,
before attaching to the network transceiver module
6
as shown.
c. Close cover.
d. Download the ATA App and follow the instructions in
the App to setup new smart hub.
e. Use a programmed remote and run the door through a
few cycles which will update the unit with the details of
the transceiver module.
6
7
Warranty
Refer to our websites for full warranty details;
www.automatictechnology.com.au
WARRANTY
ACCESSORIES
1 year
If you are a consumer under the Australian Consumer Law, our goods come with guarantees that cannot be excluded under the Australian Consumer
Law. You are entitled to a replacement or refund for a major failure and for compensation for any other reasonably foreseeable loss or damage. You
are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.
This warranty certificate and other statements contained in this document or other ATA documents given to you do not exclude, restrict or modify the
application of all or any of the provisions of the Australian Consumer Law.
Subject to your non-excludable rights under the Australian Consumer Law, ATA expressly excludes any liability for consequential loss, incidental or indirect
damages (including but not limited to damages for loss of business profits, business interruption and loss of business information) due to a defect of the
Product. In particular, any loss or damage caused to other equipment or accessories used with the product or any loss resulting from a delay in repair is
excluded to the extent permitted by law.
ATS-2
