Automatic Technology TEMPO ATS-2, Инструкция по эксплуатации

Страница: 7 / 24

7 ATS Series Instruction Manual
8. Perforated Angle
Attach Perforated Angle (not supplied) or equivalent
a. Measure across the ceiling from the centre point 3155mm (+/- 50mm) to find a supporting beam.
b. Create a perforated angle which best suits your site. Use a hack saw to cut the L shape metal strips. Secure the perforated
angle to a supporting beam using diagrams shown below.
c. Raise the drive unit to the ceiling mounted perforated angle and secure with M8x20mm screws and nuts (not supplied). Strips
should not extend more than 18mm below centre of drive unit mounting holes.
d. To prevent moisture on the C-rail running into the powerhead it is recommended a strip of silicon sealant is placed across the
top of the C-rail just before the opener.
Ceiling Beams that run towards the door requires:
1 x perforated L shape metal strip and
2 x shorter perforate L shape metal drop down strips.
Ceiling Beams that run parallel to the door requires:
2 x perforated L shape metal strips and
2 x shorter perforate L shape metal drop down strips.
(Not supplied)
9. Mounting Brackets and Arms
Mounting The Door Bracket:
a. The door bracket locator
7
is placed over the door bracket
8
, on the door’s centre line one-third down the top panel and
mounted using M6 or equivalent screws (not supplied),
b. STEEL DOORS ONLY: Bracket can be welded in place.
NOTE: If in doubt about the door’s strength, reinforcement
may be added to the door’s frame where necessary. Door
damage may occur if the bracket is installed on a panel
with insufficient strength. The opener’s warranty does not
cover damage caused to the door and/or door panels.
Attaching the Arms
a. Assemble the bent arm
4
(connecting to the door) to the
right side of the straight arm
5
with bolts
10
and nuts
13
supplied in the accessory pack. Connect the straight arm
5
to
8
7
7
12
9
4
13
6
10
9
12
8
5
the shuttle with a clevis pin
12
and a pin snap
9
. Always use both bent and straight arms.
b. Connect the assembled arm to the bracket with clevis pin
12
and pin snap
9
. The angle “A” must be more than 10°.
A