28
GDO-11v1 Ero®
Owner Installation Instructions
54
fi g
Final Setup
Step 25 - Setting the Pet Mode position
The default Pet Mode height can be changed as follows:
Make sure the door is closed, then press and hold
the PLUS(+) button for six (6) seconds
(Fig. 54)
,
until you hear three beeps and the OPEN and
CLOSE LEDs fl ash rapidly.
Press the OPEN or CLOSE button
to move the
door to the desired Pet Mode open position.
Press the SET button to record the new position.
When activated, Pet Mode drives the door to the preset
position from either above or below. Pet Mode’s active
status is indicated by both the OPEN and CLOSE LIMIT
LEDs being illuminated. If a Pet Mode button is pressed
while the door is moving the door will stop. If a Pet
Mode button is pressed when the door is in the Pet
Mode position, then the door will close.
Step 26 - Installing the Wall Mounted
Transmitter (Optional)
Remove the faceplate from the transmitter.
Affi x the baseplate in a convenient wall location
(Fig 55)
that is out of reach of children at a height
of at least 1.8 metres from the fl oor and where
the door is visible
Replace the faceplate.
To code the transmitter, see Steps 15.2 through
15.3 on page 19.
Step 27 - Reset all Factory Defaults
Turn power to opener off.
Press and hold the SET Button
(Fig 56).
Turn power on while holding the SET button.
Continue to hold until all the LED’s are off.
NOTE:
This will not erase transmitter codes stored in
the memory.
a.
b.
c.
a.
b.
c.
d.
a.
b.
c.
56
fi g
55
fi g
