12
Dominator EasyRoller Instruction Manual
6.3. Pinning the Door
6.4 Proping the Door
6.4.1 Prepare the Door:
a.
At the end opposite to where the opener will be fitted, check that the U-bolt which
holds the door axle to the bracket is tightened securely.
WARNING! The U-bolt must be done up tightly to ensure the stored energy in
the springs cannot be unexpectedly released.
WARNING!
Make sure the prop is
snug under the door and is stable.
U-bolts
Towel
Door stand
or prop
Door bracket
WARNING! Do not allow children/persons
around the door and prop.
Serious personal injury and/or property damage
can result from failure to follow this warning.
Fig. 6.4.1
6.3.1 Pinning the Door to the drum:
NOTE: Pinning of the door is mandatory and is primarily required in order for the inherent
entrapment protection to function properly.
Pinning the door’s curtain to its drum maintains
security when the opener is closed. If the curtain is not pinned the door can be partially opened
manually.
(Fig 6.3.1)
a.
Fully close the door.
b. Mark a minimum of two (2) drill holes on the drum to each end of the door.
(Fig 6.3.2)
c.
Drill holes using 3.2mm (
1
/
8
”) drill bit.
d. Fit M10 x 32mm screws and washers (not supplied) to each of the four (4) holes. This screw
should be positioned as low as possible in the grove, but make sure that it does not alter the
curtain’s normal lead in to the guide.
BALLOONING
DOOR
PINNED DOOR
FREE DOOR
Without locking bars
door can be lifted
Not pinned and
without locking bars
door can be lifted
Door secure and will
not lift
Pin Points
Screw into the
low part of grove
Fig. 6.3.1
Fig. 6.3.2
AVERTISSEMENT! Il est interdit de passer sous la porte
ou de passer à proximité du support placé sous la porte.
Le non-respect de cette consigne peut entrainer des
blessures graves ou des dommages matériels.
b. Open the door completely and tie rope around the door roll. Do not tie the rope too
tight as damage to the curtain may ensue. This will stop the door unrolling when taken
off the bracket
c.
At the end where the opener is to be fitted, support the door with a door stand or
suitable prop. Place a towel between the door and the prop to protect the door from
damage.
d. At the end where the opener will be fitted use a pencil to mark the position of the
U-bolt in the door bracket and the position of the door bracket on the wall to assist in
reassembling.
AVERTISSEMENT! Bien serrer la fixation en U de manière à contenir l’énergie
du ressort sous tension.
AVERTISSEMENT!
Vérifier que le
support est positionné correctement
sous la porte et ne risque pas de
tomber.
