8.5 SAFETY OBSTRUCTION TEST
TESTING CLOSE CYCLE
1. Open the door by pressing the Yellow O/S/C
button 4 (Fig 18).
2. Place a length of timber 100mm X 50mm on the
floor directly under the door (FIG. 17).
3. Press the Yellow O/S/C button to close door. The
door should strike the object and start to re-open.
TESTING OPEN CYCLE
1. Close the door by pressing the Yellow O/S/C
button 4. (Fig 18).
2. Press again to open the door. When the door
reaches half the opening distance grab the bottom
rail of the door firmly, the door should stop.
If the door does not reverse readily when closing, or stop
when opening, the force may be excessive and need ad-
justing, refer to
STEP 8.1, 8.2, 8.3 and 8.4.
IMPORTANT WARNING: If the door is closing and
is unable to reopen when obstructed discontinue use.
Do not use a door with faulty obstruction sensing.
Repair fault and re test before using.
9. SETTING TRANSMITTERS CODES
INTO DOOR OPENER
The Remote Transmitters and Wall Mount Transmitters
can be programmed into the Door Opener as below.
Make sure to connect the battery to the Transmitters. The
memory in the Openers receiver can store up to
27 different remote control transmitters.
9.1 STORING THE TRANSMITTERS CODE
1.
Press and hold
the blue Door Code button on the
Control Panel button 9 (FIG. 18).
2. Press the button (one of four) on the Transmitter
you would like to use to control the door for
approximately two seconds, (FIG. 18). Pause for
two seconds. Press the same button again on the
Transmitter for approximately two second.
3. Release the blue Door Code button 9.
4. Press the Transmitter button to see if it operates the
door. If you wish you can code in all four buttons on
the Transmitter so all four can operate the same door.
9.2 STORING ADDITIONAL TRANSMITTER (S)
FROM A REMOTE LOCATION
Using this method you don‟t need to have access to the
control panel on the Door Opener. However, you do need
a transmitter that is pre coded to the controller‟s receiver.
IMPORTANT NOTE: The Door must be activated
when the step below is preformed. The moving Door is
to confirm from a remote location that the correct but-
ton was pressed and the transmitter is in range of the
opener of a pre coded Transmitter.
1. Take any pre coded Transmitter. Press the button for
the function you require until the door is activated
and release.
2. Then using a small needle press and hold firmly for
2 seconds through the
Coding Hole
(Fig 18)
3. Within 10 seconds take the additional transmitter you
wish to code and follow
STEP 9.1
para
2, as above.
14
FIG. 18
I NSTALLATION
FIG. 19
