Automatic Heating Modulex E8, Инструкция по эксплуатации и руководство пользователя

Страница: 52 / 70

MODULEX CONTROLLER OPERATION
A-2
A-1. DISPLAY AREA
The DISPLAY area contains an Installation, Hot Water, Heating (HTG) Circuit 1 & 2 and a Solar Heating
Sub-Menu. The sub-menu functions associated with each of these items are listed below:
NOTE
All DISPLAY area menus are READ ONLY and cannot be changed.
Temperature readings are in °C.
DISPLAY MENU TABLE
FUNCTION DESCRIPTION REMARKS
INSTALLATION Sub-Menu
T-OUTSIDE Outside air temperature Only if outside air sensor is
installed.
T-EXT DES External Set Point value specification (0-10V)
Boiler Set Point setting in 0 to 10 volt input
mode A 0 to 10 volt external input
signal can be used to preset a
Set Point value for the control
system.
T-COLL DES Heat Source (HS) / Header Set Point value
(cascade). Boiler Set Point temperature in
Indoor/Outdoor Reset and Constant Set Point
modes.
T-COLLECTOR HS / Header Set Point temperature (cascade)
T-BOIL Press Program Key to display temperature
and ON/OFF status of individual Heat
Modules (HS) which range from 2 (MX-100)
to 7 (SMX-900). Turn Rotary Knob to
sequence between Heat Modules.
T-SOLID FUEL For HS2 = Solid fuel boiler (A7) Not Applicable
T-RETURN 1 Return flow temperature of HS 1
T-RETURN 2 Return flow temperature of HS 2
T-BUFFER T Buffer storage tank temperature - top Only if buffer storage installed
T-BUFFER M Buffer storage tank temperature - mid
charging zone HS Only if buffer storage installed
T-BUFFER L Buffer storage tank - low Only if buffer storage installed
T-STORAGE 3 Temperature of storage tank 3 (e.g. solar
pool-heating)
MODGRAD Modulation degree of HS (BUS)
RETURN Press Program Key to exit INSTALLATION
Sub-Menu.