.06.
Application use:
30
KW
Diesel Heater
DH30KW
6.1. Start-up
Fill tank with clean fuel. Only use Diesel or Kerosene.
The fuel gauge on top of the tank allows to check fuel level
Connect the power cord plug to a 230 V 50 Hz earthed electrical supply
system.
Earthing is mandatory.
When complete “start-up” above, the power indicator will light, the display
window will show the ambient temperature value.
Push the power switch to “on” position.
If the thermostat control knob setting temperature is higher than the ambient
temperature, the electrodes start sparking and after 7 seconds, the heater
starts.
If the thermostat control knob setting temperature is lower than the ambient,
turn thermostat control knob to desired temperature setting, the electrodes
start sparking and after 7 seconds, the heater starts.
COLD START-UP: at low temperature keep the air vent hole (see Fig. 6)
closed by a finger during ignition to make start-up easier.
ABNORMAL OPERATION: in case of malfunction (flame failure, reduced air
flow, bad combustion, etc.) the heater stops and the indicator light starts
FLASHING (THE LOCK-OUT MODE code will be showed on the display
window).
Cleaning and maintenance
:
Regularly wipe the enclosure using a soft sponge or cloth. For very dirty parts,
use a sponge with warm water and a mild detergent, then dry using a clean
cloth.
Keep air inlet and fan free from dust and dirt. To clean inner parts, gently blow
compressed air through air inlet.
Regularly inspect the power cable: if worn, cracked or damaged have it
replaced by technical service.
Before storing the heater, make sure it is perfectly cool and dry. Cover the unit
with a plastic bag, put it in its packing box and store it in a dry, ventilated
place.
