INSTRUCTIONS MAGRO-35A
Page 11
SWING GATE OPENER
4. Self Learning (Easy and Smart)
Checking before self-learning
1. Check the wiring of the motors
2. Check the manual release is in the locked position
3. Make sure the gates are at the fully open position.
4. There should be hard stoppers at both fully opened positions and fully closed position.
Self –Learning Setting (motor setting)
1. Press the “F” button on the PCB. If C8 is not on the display, Tap the “+” or “-“ button
until it is shown.
2. Hold down the “ Enter” button on the PCB for 3 seconds until the display starts to blink
and release the button. This enters self learning mode.
3. Self- learning is finished when C8 is steady on the display. You can now use the remote
control.
* do not operate the remote control during the above self-learning process. Press the “F”
button to exit the learning mode if you require an emergency stop. To restart the self
learning process, start from step 1
If you find problems with the gate operation in heavy winds or with other obstacles, adjust
“MOTOR SETTING” and total timer adjustment manually.
PCB Manual Adjustment
After self-learning process if manual adjustment is required to get optimum
parameters, please following below:
If opening or closing does not reach the required positions, you can increase the force
during slow speed (A6, B6) by 10 and then repeat the self- learning process.
If the speed is not slowing down at the ends of the cycle, decrease A6 and B6 by about 5
and then repeat the self learning process
.