Auto-Trail Cheyenne, Быстрое руководство

Страница: 25 / 63

Depending on the room temperature the heater will automatically select the
output of the heater required. Once the room temperature has been
reached, the heating will switch off (regardless of the water temperature).
If the boiler is full of water then it will be heated automatically at the same
time. The water temperature is however dependent on the seat output of the
heater and will switch off when the room reaches the desired temperature.
In this condition the yellow monitor lamp (g) will only light up if the water
temperature is below 5°C.
Switching Off
(Gas Operation)
Switch the heating system off at the rotary switch (f).
If the appliance is not to be used for long periods, close the isolation valve
in the gas supply line and turn off the gas cylinder.
Red Indicator ‘Failure’
In event of a fault the red monitor lamp (h) will light up. Reset the system by
switching off the heater.
230V Electrical Operation (Hot water only)
When the rocker switch is in the ‘on’ position (j) the switch will illuminate to
show that the water heater is operating. The water temperature is
automatically regulated to 60°C.
Truma Ultraheat
When your vehicle is fitted with Ultraheat, you will find a separate wall
switch with 500W, 1000W and 2000W settings.
Switching on
• Check that you have a mains supply, and that the fuse spur is
switched on.
• Turn control ring (b) to required power setting.
• Set rotary control knob (c) to desired room temperature.
The Ultraheat can either be used as an independent heater or can be used
in conjunction with the gas system to give a maximum 5.2kW output.
For night time use it is recommended that the Ultraheat system is switched
to the 500W setting.
25
auto-trail.co.uk
T H E ‘ N E X T G E N E R A T I O N ’
B
B
A
B
C
Gas: Appliances
Gas: Appliances
Truma Ultraheat
A - Slide switch: OFF
B - Rotary switch: ON
Power settings:
500-1000-2000W
C - Rotary control knob for room
temperature (illuminated by green
indicator lamp “operation’
7.