Luxury Tops
Isuzu • D-Max Mk4
4
Clean the top edge of tail-
gate using the VHB wipe
supplied or a good quality
bodywipe.
Remove the roll of tape
from the bag and cut one
end square.
6
7
Partly remove the backing from the tape.
Apply it to the tailgate, rubbing outwards to
remove any bubbles as you go.
Cut the other end square.
8
9
10
IMPORTANT
: Door and tailgate
MUST be closed for step 4.
Tighten the clamps to
8Nm Torque using the
17mm wrench (Start with
the middle clamps).
Replace the bolt caps onto
the clamps.
4
5
(Just more than hand tight / 8Nm Torque)
Electrics
Vehicle wire colours are listed as a guide.
Please check with a multi-meter before fitting the harness.
Ensure the ignition is off. Remove door
sill trim (and kick plate for the extra
cab) from the driver’s door.
Drill a suitably sized hole in the
vehicle’s floor pan. We use a bore
hole drill bit. Connect the wiring loom
from the fitting kit to the hardtop.
1
2
Pass the ‘5-wire’ leg through the
hole, into the cab.
Slide a grommet down the wire and into
the hole. Pass the wire to the front and
fill the grommet with silicon sealant.
Disconnect the hardtop.
3
4
5
