Auto Page RF-502, Руководство по эксплуатации

Страница: 10 / 18

RF-502
8
4. Turn the ignition switch "ON/OFF", "ON/OFF". The siren will chirp
one (1) time. You are now in the programming mode.
5. Press the ON/OFF button on one of the remote transmitters until the
alarm siren responds with a confirming chirp. The first transmitter is
now programmed.
Within five (5) seconds , press the ON/OFF button on the second
transmitter until the alarm siren responds with a confirming chirp.
The second transmitter is now programmed.
NOTE : If the RF-502
does not receive a second code to learn within five (5) seconds, it
will automatically close the programming mode and resume normal
alarm functions
. If this happens, it will be necessary to repeat steps
1 through 6 and re-program all transmitters. If three or four
transmitters are programmed, continue pressing the ON/OFF
button of the third and/or fourth transmitters.
6. The RF-502 can learn up to four remote transmitter codes. If later
optional third and forth transmitters are to be programmed, follow
sequence 1 through 6 and re-program
all existing transmitters.
L. PROGRAMMING REMOTE FOR SECOND VEHICLES
The RF-502 transmitters are capable of controlling separately installed
RF-502 or RF-302 alarm systems in two or three vehicles.
To code the RF-502 transmitters for two or three vehicles follow the
diagrams as shown below. Before multiple vehicle programming can be
achieved, it is necessary to enter the programming mode as described
in SECTION K.
1. TWO VEHICLE OPERATION
VEHICLE #1