9
Power Save Mode:
While in the power save mode, the LCD remote transceiver will “sleep” until a button is pushed,
to extend the life of battery. When power save mode is ON, the remote control will wake up
periodically to check for messages from the security module.
1. Press and hold all four remote control buttons simultaneously unit one long
beep is heard. Programming has now been entered.
2. Within 5 seconds, press the
button to toggle “On” or “Off”. The remote will
beep once for “On”, twice for “O f f ”. When power save mode is “On”, the
icon on the LCD screens to indicat e entry the “power save mode”
3. To exit programming mode, take no action for five seconds. The remote control
will generate two long beeps to indicate programming mode has been exited.
Screen Lamp ON:
Press the
button once; the LCD screen lamp will turn on for 5 seconds
System’s Status Check
When you want to check the system’s present status
through the LCD screen, Press the transceiver
button first, within 3 seconds
press
and buttons at the same time. It responds with one melody sound, the
LCD screen should be illuminated.
Note:
If it has no response then you are out of range.
Clear the Flash Icon and Melody Sound:
Cycle ignition then press the
button first, within 3 seconds press and
buttons at the
same time. It will clear the flash icon and melody sound on the LCD screen transceiver
Stop The Trigger Melody Sound:
While triggering the alarm the LCD screen will alert the user through melody sound and flashing
trigger icon. Press any button on the LCD remote transmitter to stop m elody sound.
