44
44
n
Important Note: A known defective battery must be replaced
before proceeding with any test on the charging or starting
system.
n
Inspect Belts
for cracks, glazed surface and fraying. Tighten loose
belts. Inspect auto-tensioner for proper belt tension.
n
Inspect Starting System.
Check starter, solenoid, and alternator for
loose connections, loose mounts and frayed or cracked wires.
n
Inspect Battery
for terminal corrosion, loose broken posts,
cracks in the case, loose hold-downs, low electrolyte level,
moisture, and dirt around the terminal.
VISUAL CHECK
Valid automotive electrical system testing depends on all
the components being in good operating condition. In
addition, the battery MUST have sufficient charge for testing. Carefully
perform the following before attempting electrical diagnosis.
INSPECTION
LIMITED WARRANTY
1 YEAR FROM DATE OF PURCHASE
CABLES 90 DAYS
The manufacturer warrants to the consumer that this product will be
free from defects in material or workmanship for a period of one (1)
year from the date of original purchase (90 Days for cables).
Products that fail within this 1-year warranty period will be repaired or
replaced at the manufacturer's option to the consumer when determined
by the manufacturer that the product failed due to defects in material
or workmanship. This warranty is limited to the repair or replacement
of parts and the necessary labor by the manufacturer to effect the repair
or replacement of the product. In no event shall the manufacturer be
responsible for special, incidental or consequential damages or costs
incurred due to the failure of this product.
Improper use, accident, water damage, abuse, unauthorized repairs
or alterations voids this warranty. The manufacturer disclaims any
liability or consequential damages due to breach of any written or
implied warranty on its test equipment.
WARRANTY AND SERVICE INFORMATION
Warranty claims to the manufacturer's service department must be
transportation prepaid and accompanied with dated proof of purchase.
This warranty applies only to the original purchaser and is non-
transferable. Shipper damage incurred during return shipments is not
covered under this warranty. It is the responsibility of the shipper (the
customer returning the Test Equipment) to package the tester properly
to prevent any damage during return shipment. Repair costs for such
damages will be charged back to shipper (customer returning the Test
Equipment). Protect the product by shipping in the original carton. Add
plenty of over-pack cushioning such as crumpled up newspaper.
55
