SAFETY INSTRUCTIONS
WARNING:
Lead Acid Batteries are Dangerous! During use and charging they may
generate EXPLOSIVE Hydrogen Gas. This means YOU MUST carefully
read all of the safety and operating instructions before using the BusPro-
620s. Be sure you understand all of the safety instructions in this manual
and on the BusPro-620s before attempting to connect, charge, or work
with a lead acid battery.
GENERAL SAFETY RULES FOR SAFE OPERATION
Batteries are dangerous. Auto Meter provides the following
Warnings
for
your safety:
1.
Use the BusPro-620s only on 12 Volt LEAD ACID AND GELLED
ELECTROLYTE (GEL-CELL) Batteries. DO NOT attempt to use on other
types of batteries (Dry Cell, Nickel Cadmium, Nickel Metal Hydride, etc.)
commonly found in small home appliances. This may cause the batteries to
burst, resulting in damage or injury to person and/or property.
2.
DO NOT use the BusPro-620s on batteries that are in use or that are
installed. Remove batteries from the vehicle and take to a properly installed
BusPro-620s location.
3.
DO NOT use attachments with the BusPro-620s that are not approved or
sold by Auto Meter. Non-approved attachments may result in injury, electric
shock, or fire and voids the warranty.
4.
When disconnecting the power cord from the wall, grasp the plug and pull.
Never pull the cord, it may damage the plug and/or the cord.
5.
Place the power cords in a location where they will not be stepped on,
tripped over, or subjected to stress or abuse of any kind.
6.
Never operate the BusPro-620s if any portion of its housing, cords or
attachments appear to be damaged in any way. If damage has occurred,
have it inspected and serviced by Auto Meter.
7.
If the BusPro-620s has been dropped, received a sharp blow, or abused in
any way, have it inspected and repaired by Auto Meter if necessary.
8.
Do not use an extension cord to operate the BusPro-620s. An inadequate
extension cord could result in fire or explosion due to a large number of
batteries being charged and will not provide the AC amperage rating needed
by the BusPro-620s.
9.
Each BusPro-620s Station has its own AC fuse. Other than this fuse
replacement, Auto Meter should be contacted for trouble shooting and
instructions on how to repair or replace parts and charging stations. Any
unauthorized repair, tampering or incorrect assembly may result in fire or
electric shock and voids the warranty. Check with Auto Meter for instructions.
10. To prevent injury during cleaning or maintenance, disconnect all batteries
and move them away from the unit. Unplug the BusPro-620s from the
wall outlet (grasping the plug). Use a slightly dampened cloth to clean the
housing and lead sets. Do not use solvents or soaps.
3
