Additional S-ONE and S-ACE panels can be added at any time, and requires no change in
the overall configuration. One must only make sure there is no IP address conflict.
The S-ONE Alarm Panel can be used as either the Main Panel or a Subpanel.
2.3 Components and Default IP Address
All Marine Watch S Series’ components have a factory-default IP address. If more than one
of each type of component is in use, then make sure to change the IP address of the extra
component.
No two components in the network shall have the same IP address.
1
From the factory, the IP address on the Subpanel is the same as for the Main Panel. This must be
changed to be unique.
Page 5 (49)
2.3.1 Main Panel
One of the S-ONE alarm panels shall in the
configuration be designated the Main Panel. This is the
default setting.
The Main Panel shall be configured and holds the
entire system configuration. Configuration is done in
the Administration submenu.
It can be done manually using the menu interface or by
loading a predefined configuration file.
Default IP address: 192.168.0.
151
2.3.2 Subpanels
Additional S-ONE alarm panels can be added in the
network, and these are called Subpanels. It must be
configured as such, under Panel Type in the
Administration menu.
Each Subpanel replicates the Main Panel and
optionally has specific use cases.
A Subpanel is automatically always in sync with the
Main Panel configuration.
Default IP address: 192.168.0.
151
1
Configuration changes are automatically also applied to all networked
Subpanels and Annunciator panels.
