AUTHOR Alarm TOR, Руководство по эксплуатации

Страница: 7 / 12

7
ATTENTION! Grey and red wires should be
simultaneously connected to power supply «+» to
connect with the IGLA anti-theft device when it is in
PIN code change mode.
Connecting IGLA and TOR
Only one TOR relay can be connected to IGLA. In order
to harmonize the devices do the following:
1. Switch IGLA to PIN-code change mode by one of the
following ways:
• connect the grey wire from IGLA to power
supply «+» and turn on the ignition;
• if the device is already connected, after the
authorization is successful enter the current
PIN-code once again while pressing the
accelerator pedal as far as it can go.
ATTENTION! If the current PIN-code include «Slight
touch on accelerator pedal», it is necessary to enter
the PIN-code once again after the authorization and
then press the accelerator pedal as far as it can go.
Then perform item 2.
2. Connect TOR relay to the wiring according the
wiring scheme above.
ATTENTION! Connection of IGLA and TOR modules
shall be done
without
connection of orange wire (status
output), yellow wire (ignition), purple, green and white-
black/brown wires (analogue locking).
3. Apply power supply «+» to grey and red wires at the
same time .