AUTEM PLC-ANALYZER pro 6, Быстрый старт

Страница: 4 / 8

PLC-ANALYZER pro 6 - PILZ PSS / PNOZ
3 / 7
Signal source
PILZ PSS / PNOZ
This driver addendum describes the particularities of the following PLC drivers and gives you hints on
using them.

PILZ PSS / PNOZ - Ethernet TCP/IP

PILZ PSS / PNOZ - programming interface
With the PLC driver "PILZ PSS / PNOZ - Ethernet TCP/IP" PLC signals can be acquired via Ethernet (TCP/IP)
and the PLC driver "PILZ PSS / PNOZ - programming interface" via the serial communication port of the
PLC.
It is important that you read through the driver addendum before using a PLC driver. Please pay
attention to the WARNINGS that advise you on possible dangers when using PLC-ANALYZER pro.
!
WARNING
Errors that may occur in the automated facility, endangering humans or causing large-
scale material damage, must be prevented by additional precautions. These precautions
(e.g. independent limit monitors, mechanical interlocks) must guarantee safe operation,
even in case of dangerous errors.
Installation
The PLC driver can be added to the project as a new signal source. If the driver you want is not yet in the
list of available signal sources, you must first activate the license for the PLC-driver with the AUTEM
LicenseManager on your computer.
Installing additional hardware
If you have already connected your PC to the PLC via a TCP/IP network or a serial cable, you normally do
not need to do anything else. Otherwise, connect your PC to the PLC.
Installing additional software
No software is required in addition to the PLC-ANALYZER pro basic module and the PLC driver.