9
10
3. Operating Instructions
1) Turn the ignition off.
,
2) Locate the vehicle s 16-pin Data Link Connector (DLC).
3) Plug into the scan tool cable connector to the vehicle,s DLC.
4) Turn the ignition on. But do not start the engine.
5) Press the
Y
button. The
Main Menu
will be observed on t he
display.
6) Use the
UP/DOWN
scroll buttons to select
VW/AUDI
from the
menu and press the
Y
button.
7) Use the
UP/DOWN
scroll buttons to select the syst em from the
Select System
menu and press the
Y
button.
3.1 VW/AUDI Diagnostics
Reading Codes
,
CAUTION: Don t connect or disconnect any test equipment with
ignition on or engine running .
Main Menu
1) VW/AUDI
2) OBDII/EOBD
3) Oil Reset
4) System Setup
Select System
01) Engine
02) Auto Trans
15) Airbags
03) ABS Brakes
08) Auto HVAC
09) Cent. Elect.
If there are no Diagnostic Trouble Codes present, the display
will indicate
NO CODES ARE STORED IN THE
MODULE!
If there are any Diagnostic Trouble Codes present, the DTC
number and its definition will show on the LCD display.
The subcode, the communication protocol, the sequence of
the DTC currently being observed and the total number of
codes detected will be observed on the upper right hand
corner of the display.
Select Function
1) Read Codes
2) Erase Codes
3) ECU Information
4) Readiness Test
If the scan tool fails to communicate with the selected
,
vehicle s ECU (Electronic Control Unit), a
LINK
ERROR! message shows up on the display.
Verify that the ignition is ON;
,
Check if the scan tool s OBD II connector is securely
connected to the vehicle,s DLC;
Verify that the module is supported;
Turn the ignition off and wait for about 10 seconds. Turn the
ignition back to on and repeat the procedure from step 5.
If the LINK ERROR message does not go away, then
there might be problems for the s can tool to communicate
with the module being tested. The most common cause is
that the scanned module is not supported on the vehicle.
The numbers (01, 02, 15, 03, 08, etc) in front of the system
names refer to the physcal addresses assigned to the systems,
not the sequence of the systems to be arranged.
8) Select
Read Codes
from the
Select Funciton
menu and press the
Y
button.
Содержание MaxiSan VAG405
Страница 1: ...OBDII Code Scanner Manual CAN VW AUDI ...
