52
4.2.3 Landing
EVO Ⅱ RTK Series V3 can be manually or automatically landed. The procedure for
landing an aircraft is as follows:
1. Manual landing
1. Find an appropriate landing position (flat and open area).
2. When the aircraft arrives above the target position, release the command stick
to hover the aircraft.
3. Slowly push down the left command stick to land the aircraft.
4. After the aircraft lands on the ground, push the left command stick all the way
until the motor is turned off.
Note
When the low battery warning (25%) is displayed, the LED indicator on the back
of the aircraft flashes red. In this case, you must immediately let the aircraft to
land on a safe place.
2. Automatic landing
When one of the following errors occur, failsafe will be triggered and the aircraft
will automatically land from the current position:
A low battery warning is displayed in a non-GPS environment.
A critical low battery warning is displayed.
